View Single Post
Old 13 May 2017, 20:02   #1
Glen M
Registered User

 
Join Date: May 2017
Location: Belfast
Posts: 76
How do I stop winuae booting from hdd

For the last few hours I've been smashing my head off the wall that is classic workbench. I'm trying to set up my 5gb ide in winuae for use on my 1200. So far I've used the install adf to partition and format the hdd. I've installed classic workbench as I want it on the hard file but each time I then mount the real hdd again winuae always tries to boot to it were l really just need it to boot to the hardfile. If I change the ide to device 1 it boots to the hardfile but the ide partitions don't appear (dh0, dh1 & dh2).

I've tried following guides but they all seem to be focused on using cf cards rather than real drives, all be it I don't see how that makes a difference.

Any idea what I'm doing wrong?
Glen M is offline  
AdSense AdSense  
 
Page generated in 0.05107 seconds with 9 queries