View Single Post
Old 06 April 2017, 18:00   #5
Richard Downer
Registered User

 
Join Date: Jun 2016
Location: Edinburgh, Scotland
Posts: 6
No, it never gets as far as booting a drive. If I remove all hard drives from the config, it still gets into a crash/reboot loop when powering on.

It seems specific to the "Accelerator board memory" option in the "Accelerator Board Settings". If it's "none" then all is well - HD boots if its attached, or insert-disk screen if not. But if this option is set to anything else (1M up to 128M) then I get the crash/reboot loop.

Thanks
Richard.
Richard Downer is offline  
 
Page generated in 0.04612 seconds with 9 queries