View Single Post
Old 31 December 2016, 10:03   #12
Toni Wilen
WinUAE developer
 
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 42
Posts: 19,523
Quote:
Originally Posted by mark_k View Post
When default.geo exists and a matching entry is found, and the user then saves the config file, it seems WinUAE puts the wrong values in the config file (Surfaces=51 instead of Sectors=51 in the example above).
I can't duplicate this. Are you sure you remembered order of parameters in config file correctly? It is sectors (51), surfaces (1), reserved (2), block size (1024). Very old historic reasons. Much later added physical geometry is in normal CHS order. It can also make it more confusing when status bar shows logical geometry in CHS order (Where C is calculated value)
Toni Wilen is online now  
 
Page generated in 0.07421 seconds with 9 queries