View Single Post
Old 06 December 2016, 09:56   #410
Toni Wilen
WinUAE developer
 
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 42
Posts: 19,520
Quote:
Originally Posted by emufan View Post
attached the config with the z3mem2 entry - but i could not reproduce this entry with a new config. no clue where it came from.
You probably had 384M Z3 selected in 3.3.0 or older. Previously there was only one slider but supported Z3 sizes are power of 2s only. 384 = 1x256+1x128.

Because 3.4+ supports multiple boards, this hack is not needed anymore and you get 2 boards when loaded to 3.4. Only first board is shown in top part of memory panel. Other boards are listed in bottom part. Check the drop down, you probably find there is Z3 #2 board with 128M RAM.
Toni Wilen is offline  
 
Page generated in 0.07221 seconds with 9 queries