View Single Post
Old 02 December 2016, 11:12   #56
Registered User
Join Date: Feb 2012
Location: #DrainTheSwamp
Posts: 4,546
Originally Posted by JZon View Post
I thought I was going to have to get my mini screw driver set and turn the adjuster until it distorted, then move it back half the number of times I counted to bring it to the center of the usable range! lol
hehe, it's a new century now, things have changed

Is there an S start up command I could enter to the user startup sequence to tell PS to automatically start itself on boot?
hmm, PS? PageStteam? just write something in s:user-startup
run > NIL: path:to/PS >NIL:

begin/end just to make the user-startup more readable
run with NIL should detach PS, so execution of user-startup will continue
may work, but not allways - maybe a cli window will be left open, hmm (!?)

you can play with WBStartup folder, just put your tool (just executable with icon)
into that folder and see what happens.

Would you happen to have creataed one for MUI38usr? (Or do I need to register to operate it? I can't seem to figure out how to enable test mode) (maybe it's looking for a keyfile or a dongle?)
attached is a working mui keyfile, put it in L: folder. other keyfiles you may find on the ftp.
Originally Posted by JZon View Post
Managed to make Birdie2000 activate, briefly...
Soon as I changed palette preferences, it disappeared. Maybe I try from scratch again..
no clue offhand, i dont use it.
i would stop birdie - configure the palette - next enable birdie again.
cannot say if that works or makes sense
Attached Files
File Type: lha mui-key.lha (5.6 KB, 42 views)

Last edited by emufan; 02 December 2016 at 11:28.
emufan is offline  
Page generated in 0.04099 seconds with 11 queries