View Single Post
Old 17 November 2016, 06:32   #17
demolition
Unregistered User
demolition's Avatar
 
Join Date: Sep 2012
Location: Copenhagen / DK
Age: 37
Posts: 3,248
Quote:
Originally Posted by JimDrew View Post
I would never recommend cleaning a disk while it is spinning. All you are doing is moving the debris to other locations and when the inner liner dries, it will drop the debris back onto the disk surface again.
True, I wasn't considering it a cleaning neither. In fact, the disk had been cut open and cleaned on both sides using IPA and a microfibre cloth before it was put into a clean sleeve for dumping. Still it would have a lot of drag since the mold had roughed up the surface quite a bit (these disks were very bad with clear white mold deposits). The IPA really helped to lubricate the cleaned platter so it could spin freely for a while until it evaporated.
demolition is offline  
 
Page generated in 0.04770 seconds with 9 queries