English Amiga Board - View Single Post

Viserion · 19 October 2016, 23:18

I really do not get this.

Have installed this before with any issue.

After gotten my Cyberstorm repaired a while a go I have let it be for a while because of other projects.

Now I tried installing AOS 4.1FE and I get so far as to run Media Toolbox, right until the moment I try to save it to disk.

Then I get "Couldn't writew RDB to disk! Write error in sector 0".
I have tried several disks, and even got "new" disk that I would be very surprised of having any contact with an Amiga in their life.

I also tried a Jaz drive, and there I could write to disk, but sadly not install to it.

Probably tried 3-4 disk, and same problem an all of them.

I have active termination at the beginning and end of disk. Only other unit on chain is a cd-rom.

Hdd has id 0, cd-rom has id 1,m and Jaz(when installed) has id 4.

Tried to change RDBBlocksLo from 0-4, and no difference.

Also tried low level format one of the HDDs I have tried, but still nothing.

Any ideas of what is going on.

Don't have a working SCSI controller in a PC, so can't try via emulation.

19 October 2016, 23:18	#1
Viserion Registered User Join Date: Mar 2013 Location: Oslo/Norway Posts: 265	AOS 4.1 problems on A4000T I really do not get this. Have installed this before with any issue. After gotten my Cyberstorm repaired a while a go I have let it be for a while because of other projects. Now I tried installing AOS 4.1FE and I get so far as to run Media Toolbox, right until the moment I try to save it to disk. Then I get "Couldn't writew RDB to disk! Write error in sector 0". I have tried several disks, and even got "new" disk that I would be very surprised of having any contact with an Amiga in their life. I also tried a Jaz drive, and there I could write to disk, but sadly not install to it. Probably tried 3-4 disk, and same problem an all of them. I have active termination at the beginning and end of disk. Only other unit on chain is a cd-rom. Hdd has id 0, cd-rom has id 1,m and Jaz(when installed) has id 4. Tried to change RDBBlocksLo from 0-4, and no difference. Also tried low level format one of the HDDs I have tried, but still nothing. Any ideas of what is going on. Don't have a working SCSI controller in a PC, so can't try via emulation.