View Single Post
Old 09 September 2016, 20:36   #18
mark_k
Registered User
 
Join Date: Aug 2004
Location:
Posts: 2,481
HDF size is not critical but it must be larger than the manual geometry specified.

You could start with the same manual geometry as needed for the Tecmar drive. (And either use the blank/empty correct-size HDF I attached above, or use an HDF >=21MB in size.)

The original Seagate ST-506 was a 5MB hard drive, but "ST-506" later came to refer to the drive<->controller interface which became a de-facto standard used by larger drives too.

The Xebec drive is 20MB, though I'm not sure of the exact capacity/geometry until I check. See this advert for it.
mark_k is offline  
 
Page generated in 0.04857 seconds with 9 queries