View Single Post
Old 04 September 2016, 15:36   #3
IvanEBC
Registered User

 
Join Date: Jun 2016
Location: Adelaide
Posts: 364
Cause i move back and forth between them, i guess i'll need to adjust it back in winuae and back again in the Amiga ... sounds like a part time job.

Here's a tricky question.

Could i use the startup-sequence to maybe check for hardware or something.

You know like ...
IF exists = WINUAE
then use uaegfx config
otherwise use standard A4000 config.

I realise this is stupidly written, but you see what i'm trying to do here, just wondered if commands existed that could do this job.
IvanEBC is offline  
 
Page generated in 0.07958 seconds with 9 queries