View Single Post
Old 03 September 2016, 04:06   #14
Bastich
Registered User

Bastich's Avatar
 
Join Date: Jul 2011
Location: UK
Posts: 253
Here is my current prototype receiver (Arduino Pro Micro) which ATM works as a HID device. I am intending on adding 9pin output so it can be used on original hardware. There is already provision on the board (once I solder a few more wires).

My current transmitter setup is also shown (Arduino Nano). It currently uses a mobile phone battery bank for power, and a patch cable to convert the 9pin socket to the boards header. I played a few emulator games using my adapter without problems. Need to test it in the lounge on the TV next

Both parts of the system have a DIL switch fitted currently allows up to 4 different signal strength and 4 different 2.4GHz channels. This may change to a 2:8 ratio to get more channels.
I have cleaned up the Arduino code for both ends of the system and they now operate at around 2-4ms which is pleasing A lot more testing with range and data rates needs to be done plus I need to source some boxs to house everything but its all looking good ATM.
Attached Thumbnails
Click image for larger version

Name:	proto Receiver.jpg
Views:	27
Size:	148.1 KB
ID:	49746   Click image for larger version

Name:	proto transmitter.jpg
Views:	24
Size:	208.2 KB
ID:	49747  
Bastich is offline  
 
Page generated in 0.05145 seconds with 10 queries