View Single Post
Old 03 September 2016, 04:02   #13
Bastich
Registered User

Bastich's Avatar
 
Join Date: Jul 2011
Location: UK
Posts: 253
Fully assembled but not yet tested transmitter prototype (Arduino Nano)
(including a 9 pin header for a joystick, its also the same foot print as the receiver)

I am intending on ether powering the transmitter by a 9v battery or a 3.7v 18650 cell but this really depends on when case I find to mount it in.

The receiver will ether be powered by the 5v line from the Amigas joystick port (will require a jumper to redirect the 5v line thou).
Alternatively (ATM) it can be used as a standard USB joypad (Standard HID device).
It will really depend on if you are using it on a PC or a Classic system in the end
Attached Thumbnails
Click image for larger version

Name:	trans proto 1.jpg
Views:	17
Size:	190.5 KB
ID:	49744   Click image for larger version

Name:	trans proto 2.jpg
Views:	11
Size:	167.0 KB
ID:	49745  
Bastich is offline  
 
Page generated in 0.04921 seconds with 10 queries