View Single Post
Old 31 August 2016, 08:57   #140
Toni Wilen
WinUAE developer
 
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 42
Posts: 19,565
Quote:
Originally Posted by michaljarz View Post
Since 3.4.0.b02 JIT always switched to the "Indirect" mode. Is it normal? "Direct" mode requires special settings?
(EDIT: Previously I wrote about Wazp3D. In Win XP doesn't work, but in Win 10 works... and in Win7 also works...)
It is not normal and it is already fixed. Including lots of edge cases if "weird" or "too much" RAM is enabled where wrong mode was selected causing possible crashes.

Quote:
Originally Posted by psykicko View Post
EDIT: I changed to UAE instead of csppc for work partition and now it works.
Ok, it could be scsi emulation related (nothing done there but side-effects are possible). Put hdf back in CSPPC scsi, run winuae with -log -scsiemulog command line parameters with only one drive mounted (in CSPPC SCSI unit that since 3.4 fails to detect anything), wait until KS boot screen appears (and no drive detected), quit, attach winuaelog.txt.
Toni Wilen is offline  
 
Page generated in 0.04974 seconds with 9 queries