View Single Post
Old 08 May 2016, 16:31   #470
Schoenfeld
electricky.
 
Join Date: Jun 2010
Location: out in the wild
Posts: 1,243
Even if you'd have the technical knowledge and equipment, you could not help as much as my logic analyzer can do: I can use free pins of the RapidRoad CPLD to trigger the logic analyzer if the IRQ enable bit toggles from 1 to 0. I can then look at the address lines on the Z3 bus and tell exactly what address is causing the trouble.

In short: You'd need the CPLD source, and that's not public. I have a few more days with the ACA500plus, then I can free the development-place for the next debugging session of RapidRoad in Z3 mode.

Jens
Schoenfeld is offline  
 
Page generated in 0.08578 seconds with 9 queries