View Single Post
Old 06 May 2016, 17:48   #44
Leandro Jardim
Registered User
Leandro Jardim's Avatar
Join Date: Nov 2009
Location: Legoland
Age: 39
Posts: 1,223
Originally Posted by Anubis View Post
You have minimum and maximum CPU rates, just make sure it is set for both 100% (or very close) when on AC.

When I was testing this, only older computers did not have this issues with JIT.
This is what I have done before: set AC power minimum/maximum CPU rate to 100/100 and battery power min/max CPU rate to 30/100. It doesnt works. All other applications and emulators I use works accordingly to the advanced power settings configuration that I put there and work well, only WinUAE that not.

Originally Posted by Toni Wilen View Post
Nothing is guaranteed in "power saver" mode but setting low frequency high only makes useless heat..

Find some (overclocking) utility that shows CPU frequency in realtime to see what actually happens.
Yes, it's because of that which I have set battery power minimum CPU rate to 100% and after that to 30%.

Originally Posted by Anubis View Post
The real question would be how JIT settings hits power setting mode on CPU.
Yes good point, this is exactly where I would like to did reached before: why releases after WinUAE 2.9.0b25+ affects the power settings of the CPU, when b24- does not!

Last edited by Leandro Jardim; 06 May 2016 at 18:35.
Leandro Jardim is offline  
Page generated in 0.04070 seconds with 10 queries