View Single Post
Old 08 March 2016, 15:44   #130
Toni Wilen
WinUAE developer
 
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 42
Posts: 19,529
Quote:
Originally Posted by Locutus View Post
I hope this isn't to terribly offtopic, but would it be possible to have a commandline argument or config setting to supress this check? I use WinUAE in WINE which works perfectly however it always complains about the Dx runtime which is annoying.
You didn't ask the correct question: Does it stay in D3D mode or does it fall back to DirectDraw after the message? (Answer is most likely "DirectDraw" so set your config to use DirectDraw instead of Direct3D)
Toni Wilen is offline  
 
Page generated in 0.05573 seconds with 9 queries