View Single Post
Old 12 February 2016, 22:35   #5
mark_k
Registered User
 
Join Date: Aug 2004
Location:
Posts: 2,483
There are quite a few of these animation disks, so rather than patching each one, one workaround is this.

In display settings, set Interlaced line mode to Single. You have to set (non-interlaced) Line mode to Single in order to do that. [That isn't ideal because then Workbench appears half its normal height, assuming you normally use Double line mode.]
Then configure WinUAE to stretch the display height by 2✕.

This brings up a suggestion for WinUAE: Add a Double option for Interlaced line mode. That would be like Single, except double height. Then the user could set Interlaced line mode to Double and have these animation disks play with no combing/fringing artifacts.

The patch to ShowANIM above is because code in ShowANIM does the equivalent of the "Lacer 1" command, i.e. it forces interlace to be globally enabled by setting the LACE bit in the gb_system_bplcon0 field of GfxBase.

Last edited by mark_k; 12 February 2016 at 22:44.
mark_k is offline  
 
Page generated in 0.05340 seconds with 9 queries