View Single Post
Old 09 January 2016, 18:42   #3
sigma63
Registered User

 
Join Date: Oct 2014
Location: Berlin
Posts: 79
Hello Toni,

i looked at the Sources (mainly hardfile.cpp) and discovered, that you support the PMI-Bit in the Read Capacity(10) Command.

Unfotunately there is the same Error as in older Versions without the PMI-Bit set:
your returned Value in " RETURNED LOGICAL BLOCK ADDRES" is one to High!

I cite from the specs: "A PMI bit set to one specifies that the device server return information on the last logical block after that specified in the LOGICAL BLOCK ADDRESS field before a substantial vendor-specific delay in data transfer may be encountered".

Could you please fix that bug. TIA
sigma63 is offline  
 
Page generated in 0.04639 seconds with 9 queries