View Single Post
Old 24 October 2015, 20:46   #34
DamienD
Global Moderator

DamienD's Avatar
 
Join Date: Aug 2005
Location: London / Sydney
Age: 40
Posts: 8,979
I tried the newer version that you uploaded; no difference from the one earlier today.

Quote:
Originally Posted by Toni Wilen View Post
I understand that scanlines disppear but you said 'anything set under "Extra Settings" disappears.' Select box becomes empty? Unselectable? Values get zeroed? What?
Sorry, I wasn't clear with my explanation. After swapping modes if I press F12 to go back to the GUI and look at the Filter --> Extra Settings area all values are still shown correctly but not rendered on screen.

Quote:
Originally Posted by Toni Wilen View Post
Do following: load your config, save it again with different name. Quit winuae, load new config, cause scanline disappearance, enter GUI, save config with yet another name. Attach both config files.
I hope I've done this correctly. Attached are:
... original Pang config (Pang.uae).
... 1st steps (Pang_Test.uae).
... 2nd steps (Pang_Test2.uae)

Quote:
Originally Posted by Toni Wilen View Post
It is normal when centering options are enabled. It is impossible to detect between scrolling and non-centered image. Both are same technically..
I hear what you're saying and wish I could offer more.

It all used to work fine in v1.0.0 and then up until v2.3.0 from testing. No jerking or pixels left at the bottom of the screen.
Attached Files
File Type: uae Pang.uae (10.8 KB, 24 views)
File Type: uae Pang_Test.uae (17.9 KB, 22 views)
File Type: uae Pang_Test2.uae (23.0 KB, 21 views)
DamienD is online now  
 
Page generated in 0.05370 seconds with 10 queries