View Single Post
Old 08 October 2015, 12:28   #2
Registered User
thomas's Avatar
Join Date: Jan 2002
Location: Germany
Posts: 5,603
If you create a HDF of a partition you have to note the geometry of it (use the partition information menu item in TSGUI) and enter the values in WinUAE when you add the HDF to the harddrives list.

If you create a HDF of the entire harddrive with all its partitions (TSGUI calls it a RDF), then WinUAE should automatically switch into RDB mode.

The same should happen if you create the HDF with WinUAE.
thomas is offline  
Page generated in 0.05650 seconds with 9 queries