View Single Post
Old 20 August 2015, 02:37   #195
Registered User
Join Date: Aug 2014
Location: Brindisi (Italia)
Posts: 2,398
Originally Posted by Toni Wilen View Post
Set correct extended memory amount in BIOS. (Everything was manual in ancient PCs..)
Found the right values, used a converter

Not sure if this causes problems but set harddrive 0 in bios, not 1 (slave only config may not be supported)
The problem is that I see the HD only when set to Slave "harddrive 1", if I configure the BIOS on the HD Master "harddrive 0" I get the error "1782- disk controller failure"

(Also enable DF0:, you only slow down booting if you disable DF0)
Tried to activate DF0 but nothing changes!

New screenshots showing the internal start Floppy/HD

Last edited by AMIGASYSTEM; 04 March 2016 at 16:46.
AMIGASYSTEM is offline  
Page generated in 0.05731 seconds with 9 queries