View Single Post
Old 27 July 2015, 22:54   #58
Toni Wilen
WinUAE developer
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 43
Posts: 20,650
Originally Posted by Amiga_CDTV View Post
How can I attach a floppy image to the emulated A1060 Sidecar?

I have now tested couple of A1060 boot disks (fe. TOSEC's A1060 PC Sidecar System Disk (1985)(Commodore)(A1000).zip and "A1060 Workbench 1.2D" from my own floppy) and all I get is either:
- RAM counts up, then it quickly shows "Drive A: Bad" and starts again
- no RAM count, says "No printer found" and stays there

This was with an A1000, KS1.2, with the A1060 ROM from the recent Zone'd archive.

As different system disks give different results, does the floppy actually have some settings for the Sidecar?
See posts in previous page of this thread. You are booting a PC: you need PC formatted boot disk, not Amiga formatted disks (ADF). At least until someone creates virtual Janus HD image.

You need to configure DF2: as PC Bridge drive with 40 tracks and have PC formatted 360k (DOS) boot disk. Check the zone for working MSDOS boot disk.
Toni Wilen is online now  
Page generated in 0.12035 seconds with 9 queries