Thread: Protection Bits
View Single Post
Old 08 May 2003, 22:49   #6
JohnH
 
Posts: n/a
Thanks everyone for your replies, I have probably installed it incorrectly. From the OS3.9 cd I created an emergency disk adf, then I formatted the hard drive from it,then I installed OS3.9 the result being that only the R and E bits were set.
I have reinstalled it this way:
Used the adf`s created from my original Workbench 3.0 and HD-install disks to install OS 3.0.
Installed Idefix97 for the CD
Upgraded from OS3.0 to OS3.9 using the OS3.9 CD.
A perfect installation and all protection bits are now set correctly.
Thanks again for your replies
 
 
Page generated in 0.04546 seconds with 9 queries