View Single Post
Old 10 June 2015, 13:40   #19
ajk
Registered User
ajk's Avatar
 
Join Date: May 2010
Location: Helsinki, Finland
Posts: 914
You should be able to get to the "Early Startup Control" by holding down both mouse buttons as you switch the power on. There you can select "Boot With No Startup-Sequence" which should bring you to a blank command line window. Type in "loadwb" and enter, you will probably get a few windows pop up that you need to cancel but Workbench should load up behind the command line window (which you can resize or close).

As to how to get Workbench back to normal... most likely you need to edit or entirely replace the sys:s/startup-sequence script, but I am not familiar with Parbench. Perhaps someone here will know how it works.
ajk is offline  
 
Page generated in 0.04562 seconds with 9 queries