View Single Post
Old 20 May 2015, 10:09   #1
Retrofan
Ruler of the Universe

Retrofan's Avatar
 
Join Date: Mar 2010
Location: Lanzarote/Spain
Posts: 5,585
Send a message via Skype™ to Retrofan
HD installation problems

Hi:
I've just prepared a 40Gb Fujitsu HD that I had spare from an old laptop. I've cleaned it, deleted any partition, run WinUAE 3.0.0 as administrator and selected it as UAE HD. Then I've made three partitions using HDToolbox from the 3.1 Install disk (SCSI_DEVICE_NAME=uaehf.device) and PFS3AIO from Aminet as File System (aio-handler-custom)

To connect the HD I've used a USB bridge adaptor. The installation was perfect and I can install this HD anytime on WinUAE and it boots and runs ok.

In the amiga it doesn't boot, no partition is shown and using HDToolbox I would have to use define new.

I have a Fast Ata MKII installed in my A1200 and also an ACA1231/42, nothing else added.

Any help is very appreciated.

Last edited by Retrofan; 20 May 2015 at 10:16.
Retrofan is offline  
AdSense AdSense  
 
Page generated in 0.05201 seconds with 9 queries