View Single Post
Old 17 May 2015, 11:24   #4
Toni Wilen
WinUAE developer
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 43
Posts: 20,635
Sources come with ipctester.cpp that was used to test pipe sending and receiving. Perhaps it helps.

It is nearly same as writing debugger commands directly to console window, only difference is that it supports also other than debugger commands which requires prefixes or targeting command. (Check uaeipc.cpp for prefixes)

All debugger routines expect command as a string, then they parse it and do the command. There is no routines that take "normal" parameters. (like address and length). As I said, there as never need previously

For example "instruction_breakpoint()" takes string, then parses it, then adds/removes breakpoint.

There is also plans for "real" UAE debugger interface:
Toni Wilen is offline  
Page generated in 0.09837 seconds with 9 queries