View Single Post
Old 19 April 2015, 18:40   #4
Megol
Registered User

Megol's Avatar
 
Join Date: May 2014
Location: inside the emulator
Posts: 228
Given your listing of liquid nitrogen I guess you really mean the most efficient way?
Slowly grid the package until the die is exposed then use spray nozzles to apply a thin film of a coolant liquid onto the die. The coolant will then evaporate - a very efficient way to remove excess heat. The liquid will probably need to be cooled down to liquid form for a practical (read: closed loop) system.


But the best realistic solution would be the heatpipe one, close to the same efficiency but much easier to do. It also works by boiling a liquid but can't by design be as efficient as a custom cooling system. Not that it matters for a 060 - they simply don't get hot enough.
Megol is offline  
 
Page generated in 0.08441 seconds with 9 queries