View Single Post
Old 11 March 2015, 14:12   #10
Registered User

Join Date: May 2014
Location: hampshire
Posts: 64
(hopefully) final update...
I had trouble slicing the top with slic3r and after talking to some 3D print bods, found that it needed 'fixing' so it's been run through netfabb, and now the top stl has gone down from 7Mb to 1.5, and it slices nicely.

of course it still needs support generated and in slic3r that means unticking "don't support bridges" (unless your printer can bridge 10ish cm of gap...)
ali-b is offline  
Page generated in 0.03933 seconds with 10 queries