View Single Post
Old 21 February 2015, 22:39   #91
Toni Wilen
WinUAE developer
Join Date: Aug 2001
Location: Hämeenlinna/Finland
Age: 43
Posts: 20,657
Originally Posted by mark_k View Post
Also, I noticed some log messages on booting my A-Max HDF connected to Supra controller (after putting suprascsi.amhd in the Devs drawer). Booting to Workbench there were a few lines of
raw_scsi_put_data but bus phase is 3!

Running A-Max, when it was booting from the Mac partition there were many lines of
raw_scsi_put_data but bus phase is -2!

Maybe a Supra software bug, if not a WinUAE issue?
It is probably "soft scsi" emulator bug, it isn't perfect yet, it has some assumptions that are not exactly correct. Those messages should be harmless if program still runs normally.
Toni Wilen is offline  
Page generated in 0.15824 seconds with 9 queries