View Single Post
Old 10 February 2015, 22:50   #75
mark_k
Registered User
 
Join Date: Aug 2004
Location:
Posts: 2,515
Thanks, it gets further now, in fact installation seems to complete. I continued accepting the defaults and the installer created two 25MB partitions, formatted them and copied files to one. Then it created a boot floppy disk. After that it tells you to reboot with the boot floppy in DF0:. (Archive with HDF and boot floppy attached; remove .zip extension before unpacking it.)

[I think I forgot to enable RDB mode for the HDF in the config I attached above. You should do that before running the installer, if you want to run it yourself.]

On booting the boot floppy, its startup-sequence runs BindDrivers (which loads the driver, which automatically mounts the partitions) then transfers control to the HD. After a short while though the startup sequence is interrupted, saying SYS:gvpscripts/tstGVPscsi failed returncode 20

I'll look at the tstGVPscsi code to see what it might be doing. But the last SCSI lines in the log were:
-> DATAOUT=512 ST=0 SENSELEN=0 REPLYLEN=0
SCSIEMU HD 0: 08.00.68.C4.01.00.00.00.00.00.00.00 CMDLEN=6 DATA=067A0C18
-> DATAOUT=512 ST=0 SENSELEN=0 REPLYLEN=0
SCSIEMU HD 0: 08.00.68.C5.01.00.00.00.00.00.00.00 CMDLEN=6 DATA=067A0C18
-> DATAOUT=512 ST=0 SENSELEN=0 REPLYLEN=0
SCSIEMU HD 0: 1B.00.00.00.01.00.00.00.00.00.00.00 CMDLEN=6 DATA=067A0C18
-> DATAOUT=0 ST=0 SENSELEN=0 REPLYLEN=0

So it looks like it issues a START STOP UNIT command.
Attached Files
File Type: zip GVP_SeriesI.tar.xz.zip (272.9 KB, 72 views)
mark_k is offline  
 
Page generated in 0.05066 seconds with 10 queries