English Amiga Board


Go Back   English Amiga Board > Search Forums

Showing results 1 to 40 of 7511
Search took 0.66 seconds.
Search: Posts Made By: Jope
Forum: support.Hardware Today, 15:07
Replies: 36
Views: 767
Posted By Jope
If your trapdoor card has an on/off switch, then...

If your trapdoor card has an on/off switch, then it is just as easy or difficult as for the rev6 and onwards. Swapping the Agnus is of course always a bit exciting if it's been in place for 30 years.
Forum: support.Hardware Today, 12:05
Replies: 3
Views: 90
Posted By Jope
The RTC should work with the Toshiba chip, so...

The RTC should work with the Toshiba chip, so yours has failed.
Forum: Retrogaming General Discussion Today, 10:41
Replies: 13
Views: 232
Posted By Jope
Out of these, I prefer Platoon. But is it a DW or...

Out of these, I prefer Platoon. But is it a DW or a Jonathan Dunn composition?

Bad Company has the hallmark DW mannerisms, so in a way that's the ideal DW tune of these. :-)
Forum: support.Hardware Today, 10:22
Replies: 4
Views: 140
Posted By Jope
It's not a common failure point in an A2000, but...

It's not a common failure point in an A2000, but that doesn't mean it can't fail. :-)
Forum: support.Hardware Today, 10:21
Replies: 3
Views: 90
Posted By Jope
I believe I've seen a working RTC with a Toshiba...

I believe I've seen a working RTC with a Toshiba GARY, but it's been a while.

IMO you ought to just replace it with a CSG GARY and be happy. :-)
Forum: support.Hardware Yesterday, 13:20
Replies: 4
Views: 140
Posted By Jope
More precisely, the Buster in the A2000 handles...

More precisely, the Buster in the A2000 handles bus arbitration for Zorro II cards. Basically it allows the cards to request and relinquish 68000 bus ownership for DMA transfers.

The...
Forum: Hardware mods 15 January 2020, 12:03
Replies: 10
Views: 138
Posted By Jope
Yes. You can get the connector off the A500...

Yes.

You can get the connector off the A500 keyboard controller and just solder a bunch of wires from it to the keyrah?

So you have an A1200 case and wish to install an A500 mitsumi keyboard?
...
Forum: Hardware mods 15 January 2020, 09:47
Replies: 10
Views: 138
Posted By Jope
Well the question you should ask: are the matrix...

Well the question you should ask: are the matrix and edge connector identical, and the answer is yes.



The mitsumi keyboard is the most common and has a single wide flat cable that connects the...
Forum: Hardware mods 14 January 2020, 22:32
Replies: 10
Views: 138
Posted By Jope
It already has an a1200 connector if it's a...

It already has an a1200 connector if it's a mitsumi keyboard. However it is quite a short one. Perhaps you can lengthen it.
Forum: News 13 January 2020, 11:55
Replies: 396
Views: 60,635
Posted By Jope
No PFS3 driver (kernel or FUSE) exists...

No PFS3 driver (kernel or FUSE) exists unfortunately.
Forum: support.Hardware 13 January 2020, 11:54
Replies: 5
Views: 268
Posted By Jope
Upgrade to 3.1.4(.1) for correct sizes on...

Upgrade to 3.1.4(.1) for correct sizes on partitions above 2GB.
Forum: MarketPlace 12 January 2020, 09:59
Replies: 2
Views: 201
Posted By Jope
The DMAC4 was only shipped with the A3000T/040 as...

The DMAC4 was only shipped with the A3000T/040 as far as I know.

Good luck with your search! The last DMAC4 I ever found was back in 2008 or so, and silly me - I sold it with that A3000 back then...
Forum: support.Hardware 12 January 2020, 09:44
Replies: 12
Views: 324
Posted By Jope
It has to access RAM at regular A500 speeds, so...

It has to access RAM at regular A500 speeds, so basically any speed improvement you will see is going to be for long running loops small enough to fit in the 030 caches.
Forum: support.Hardware 11 January 2020, 21:10
Replies: 184
Views: 24,129
Posted By Jope
Heh, mine replaced the PIV, X-Surf100+RapidRoad....

Heh, mine replaced the PIV, X-Surf100+RapidRoad. For the first time I didn't feel at all sad when removing the PIV from a machine. :-D
Forum: support.Hardware 10 January 2020, 20:01
Replies: 184
Views: 24,129
Posted By Jope
I'd love something like this as a standalone...

I'd love something like this as a standalone device, which converts a multi function USB device (such as Logitech Unifying) to native Amiga keyboard and mouse connectors. :-)
Forum: support.Hardware 10 January 2020, 08:30
Replies: 4
Views: 244
Posted By Jope
Yes, and again, you need a step up transformer...

Yes, and again, you need a step up transformer 110 -> 220V.
Forum: support.Hardware 09 January 2020, 14:07
Replies: 6
Views: 193
Posted By Jope
So you have the fabled B pal in yours then? :-)

So you have the fabled B pal in yours then? :-)
Forum: support.Hardware 09 January 2020, 11:40
Replies: 184
Views: 24,129
Posted By Jope
In the end, which USB devices would you need the...

In the end, which USB devices would you need the most? For me it would probably be massstorage and rs232. Ethernet is already provided by the zz9000..
Forum: Hardware mods 08 January 2020, 19:19
Replies: 278
Views: 21,586
Posted By Jope
A RAS jumper similar to JP3 on the Rev6-8 A500...

A RAS jumper similar to JP3 on the Rev6-8 A500 board perhaps?
Forum: support.Hardware 08 January 2020, 15:48
Replies: 15
Views: 350
Posted By Jope
Up and down should work perfectly even by just...

Up and down should work perfectly even by just rubbing the tip of your finger against the roller in the mouse ball cavity. I'm assuming the 005AGIMA tried this already?

A common fault with tank...
Forum: Hardware mods 08 January 2020, 15:46
Replies: 278
Views: 21,586
Posted By Jope
Yep, it wouldn't be a stable configuration with...

Yep, it wouldn't be a stable configuration with two chips being selected for the same memory area.
Forum: support.Hardware 08 January 2020, 08:36
Replies: 31
Views: 880
Posted By Jope
Based on the memory map you posted before, it...

Based on the memory map you posted before, it will work.. At least the A590 contains 2MB of contiguous fast ram.
Forum: support.Hardware 07 January 2020, 15:38
Replies: 31
Views: 880
Posted By Jope
Good luck finding the equations for burning one...

Good luck finding the equations for burning one these days. Apparently you had to order it from the manufacturer in the first place.
Forum: support.Hardware 07 January 2020, 13:21
Replies: 93
Views: 29,460
Posted By Jope
The Asus PB248Q from 2014 does 15kHz via VGA...

The Asus PB248Q from 2014 does 15kHz via VGA quite nicely. Also works fine with the OSSC. The aspect ratio cannot be locked to 4:3 when the VGA input is selected, but it can be done for HDMI signals.
Forum: support.Hardware 07 January 2020, 10:44
Replies: 2
Views: 151
Posted By Jope
I don't think an actual DVORAK keyboard was ever...

I don't think an actual DVORAK keyboard was ever created, but other than that, I believe each keymap corresponds to an actual shipping Amiga keyboard. Some of the Amiga service manuals are available...
Forum: support.Hardware 07 January 2020, 10:06
Replies: 5
Views: 268
Posted By Jope
Any calculator that has multiplication is handy...

Any calculator that has multiplication is handy enough here.

When you define the hard drive, note down the heads + sectors per track from that screen.

When you create partitions, it is...
Forum: support.Hardware 07 January 2020, 10:03
Replies: 15
Views: 350
Posted By Jope
The cable might have an internal break, usually...

The cable might have an internal break, usually near where it enters the mouse.
Forum: support.Hardware 07 January 2020, 08:19
Replies: 8
Views: 456
Posted By Jope
As long as you have a correctly installed 3.1.4...

As long as you have a correctly installed 3.1.4 setup on your hard drive, it will work from any floppy you boot from too. If you don't have a hard disk, it will ask you to insert your Install 3.1.4...
Forum: support.Hardware 07 January 2020, 08:09
Replies: 184
Views: 24,129
Posted By Jope
Based on what I understand from discussions about...

Based on what I understand from discussions about this, it might never get one.

However this is open source.. ;-)
Forum: support.Hardware 06 January 2020, 13:26
Replies: 18
Views: 822
Posted By Jope
There is new information. 3.9 and 3.1.4 have...

There is new information. 3.9 and 3.1.4 have support for ide splitters built in, but it is not enabled as it might not be stable.

Try it and see:...
Forum: support.Hardware 04 January 2020, 21:48
Replies: 184
Views: 24,129
Posted By Jope
The Zorro2 side of things has been languishing a...

The Zorro2 side of things has been languishing a bit lately, but some progress was posted recently:


https://twitter.com/mntmn/status/1213516684427976705
Forum: support.Hardware 03 January 2020, 15:58
Replies: 31
Views: 880
Posted By Jope
Ah yes, it was even weirder than I thought. ...

Ah yes, it was even weirder than I thought.

Definitely the B PAL configuration and only add the enough memory to get the second 512k of chip ram + 1.5MB ranger fast would be (to me) the ideal...
Forum: support.Hardware 03 January 2020, 14:18
Replies: 31
Views: 880
Posted By Jope
Seems you are in luck, it won't conflict. Very...

Seems you are in luck, it won't conflict. Very puzzling that they decided to do it this way. Your system might benefit from a mergemem command being run after cRAM, however it might not work since...
Forum: support.Hardware 03 January 2020, 13:19
Replies: 8
Sticky: Amiga Problems
Views: 35,064
Posted By Jope
If the rubber feet in your Amiga are missing or...

If the rubber feet in your Amiga are missing or turning into goo, the following 3M products work as replacements:

Wedge Amigas: 3M Bumpon SJ5012
A4000: 3M Bumpon SJ5744
Forum: Amiga scene 03 January 2020, 09:46
Replies: 54
Views: 2,872
Posted By Jope
Mostly tradition. A standard DOS disk can be...

Mostly tradition. A standard DOS disk can be copied with a wide variety of copiers, a custom format would require a custom copier, or otherwise it would require everyone to agree on a new warez...
Forum: support.Hardware 03 January 2020, 09:26
Replies: 9
Views: 1,536
Posted By Jope
All the component changes you need are the...

All the component changes you need are the correct Agnus and the correct crystal to convert the A2000. I recommend using the crystal that corresponds to the screen mode the machine will mainly be...
Forum: support.Hardware 03 January 2020, 09:21
Replies: 7
Views: 313
Posted By Jope
I'm willing to bet that the vast majority of...

I'm willing to bet that the vast majority of Amigas ever sold (germany + the nordics) needed those extra keys, as our keymaps use them for <> '*. :-)
Forum: support.Hardware 02 January 2020, 14:41
Replies: 27
Views: 1,205
Posted By Jope
PDS3 = PFS3 but directscsi instead of TD64...

PDS3 = PFS3 but directscsi instead of TD64 access. The dostype alone does not tell you which version you're running, you can instead say version dh0: (or whatever your boot device name is) to see.
...
Forum: support.Hardware 02 January 2020, 10:15
Replies: 31
Views: 880
Posted By Jope
So you have it running at the moment? Please...

So you have it running at the moment? Please provide us with info on what address ranges the blocks of memory occupy once you have run the cRAM command.

You can browse the memory blocks in sysinfo...
Forum: support.Hardware 02 January 2020, 09:58
Replies: 5
Views: 277
Posted By Jope
Both should work.

Both should work.
Showing results 1 to 40 of 7511

 
Forum Jump

All times are GMT +2. The time now is 18:22.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Page generated in 0.49204 seconds with 10 queries