English Amiga Board


Go Back   English Amiga Board > Search Forums

Showing results 1 to 40 of 9289
Search took 1.05 seconds.
Search: Posts Made By: Jope
Forum: support.Hardware Today, 09:55
Replies: 272
Views: 69,341
Posted By Jope
It is not possible to replace the chipset via the...

It is not possible to replace the chipset via the trapdoor slot.
Forum: support.Hardware Today, 09:23
Replies: 2
Views: 69
Posted By Jope
How do you factor in partition alignment for...

How do you factor in partition alignment for those 4k blocks? The geometry will be based on 512k blocks, does the 3.2 HDTB calculate a suitable geometry so that the partition that begins after the...
Forum: Retrogaming General Discussion Yesterday, 13:02
Replies: 29
Views: 1,000
Posted By Jope
The difficulty goes back and forth. Sometimes you...

The difficulty goes back and forth. Sometimes you end up in a really difficult place and have to go back to your previous code and complete that level again with a different amount of energy...
Forum: support.Hardware 02 December 2022, 19:41
Replies: 5
Views: 129
Posted By Jope
Probably there is no firmware involved, those...

Probably there is no firmware involved, those drives most likely just have logic gate ASICs in them, not anything that would run code.

Your mods look like the ones in the instructions, did you...
Forum: support.Hardware 02 December 2022, 11:06
Replies: 10
Views: 201
Posted By Jope
The change for 3.1 was deliberate. The releases...

The change for 3.1 was deliberate. The releases before that are buggy.

It being a beneficial bug doesn't change the fact that it is not always stable to have the RAM <-> PCMCIA overlap.

So of...
Forum: support.Hardware 01 December 2022, 20:50
Replies: 5
Views: 129
Posted By Jope
It might be a failing CIA. Ready and diskchange...

It might be a failing CIA. Ready and diskchange go to the same chip.

Can you photograph your modification to the drive so that we can double check?

If you remove the wire between TP15 and pin...
Forum: support.Hardware 28 November 2022, 18:37
Replies: 7
Views: 259
Posted By Jope
The clock halving is done by the 7474 chip next...

The clock halving is done by the 7474 chip next to the RTC battery. The 040/060 jumper selects whether the oscillator's signal goes directly to the CPU socket or via the 7474.

No idea about the...
Forum: support.Apps 28 November 2022, 14:04
Replies: 28
Views: 1,662
Posted By Jope
It's true, there is no Num Lock key that ASM-One...

It's true, there is no Num Lock key that ASM-One detects.

NumLock is a menu item in the Preferences menu of ASM-One 1.02. And it's ghosted when you're in the editor, so you must first hit esc to...
Forum: support.Hardware 27 November 2022, 20:21
Replies: 17
Views: 1,082
Posted By Jope
Yes, the tiny line.

Yes, the tiny line.
Forum: support.Hardware 27 November 2022, 17:50
Replies: 391
Views: 88,806
Posted By Jope
https://source.mnt.re/amiga/zz9000-firmware/-/rele...

https://source.mnt.re/amiga/zz9000-firmware/-/releases

ZZ9000 Amiga Driver Installer Package 1.12 (LHA) is visible there. Unfortunately Gitlab is not at all Amiga web browser friendly. You could...
Forum: support.Hardware 27 November 2022, 15:48
Replies: 7
Views: 298
Posted By Jope
Rev 6 shouldn't have this particular problem, the...

Rev 6 shouldn't have this particular problem, the fix is related to 4.1 and older boards.

They are caps, yes.
Forum: support.Hardware 27 November 2022, 12:53
Replies: 7
Views: 298
Posted By Jope
Perhaps it's this problem if it is an early...

Perhaps it's this problem if it is an early board: Rev. 4.2 (to solve first keystroke problem delete C910/C911)
Forum: Hardware mods 24 November 2022, 21:48
Replies: 56
Views: 21,701
Posted By Jope
You could try adding Mount=1 to your mountlist to...

You could try adding Mount=1 to your mountlist to get it activated without CD.
Forum: support.Hardware 23 November 2022, 17:55
Replies: 6
Views: 304
Posted By Jope
Add PFS3aio from Aminet to your RDB and configure...

Add PFS3aio from Aminet to your RDB and configure your partitions to use it. It will attempt to use DirectSCSI for the partitions over 4GB. Dostype 0x50465303.

Do you have the latest firmware in...
Forum: support.Hardware 20 November 2022, 09:58
Replies: 3
Views: 615
Posted By Jope
This ICL branded one is an example of the...

This ICL branded one is an example of the recessed plunger type. The caps will be directly compatible with A500,600,1200 Mitsumi keyboards.
Forum: Hardware mods 18 November 2022, 13:05
Replies: 499
Views: 124,563
Posted By Jope
Just extrapolating from this note in the readme...

Just extrapolating from this note in the readme file. Also it used to be common practice that you must use a matching stub lib to your cpu lib (p5 vs apollo for example).
Forum: Hardware mods 18 November 2022, 07:52
Replies: 499
Views: 124,563
Posted By Jope
Maybe. Which stub 040 lib did you use? I...

Maybe.

Which stub 040 lib did you use? I believe the 0x0 lib included in mmulib also has some functionality in it, so ideally you should not mix and match cpu libraries from different sources.
Forum: Hardware mods 17 November 2022, 15:05
Replies: 499
Views: 124,563
Posted By Jope
This is why the mmulib installer patches setpatch...

This is why the mmulib installer patches setpatch for you to search for 680x0.library instead, which is the stub library in this case.

V46 and above setpatches don't need to be patched, and they...
Forum: request.Apps 16 November 2022, 13:33
Replies: 5
Views: 383
Posted By Jope
He's the same dude.

He's the same dude.
Forum: support.Hardware 16 November 2022, 11:02
Replies: 17
Views: 1,082
Posted By Jope
Good that you got it working! About the...

Good that you got it working!

About the jumper, it looks like the pins were already shorted by a trace on the circuit board?
Forum: support.Hardware 16 November 2022, 10:58
Replies: 2
Views: 140
Posted By Jope
Try Bossard 2000237 (TME SKU B30X6/BN13577) .. or...

Try Bossard 2000237 (TME SKU B30X6/BN13577) .. or if not exactly those, then you can look at the datasheet and find similar ones from a local fastener shop. Anyway, those are the ones I used to screw...
Forum: Hardware mods 16 November 2022, 10:56
Replies: 15
Views: 872
Posted By Jope
This goes in the CPU socket of an A500.

This goes in the CPU socket of an A500.
Forum: support.Hardware 15 November 2022, 10:14
Replies: 391
Views: 88,806
Posted By Jope
The USB works for mass storage devices and there...

The USB works for mass storage devices and there is a separate Amiga driver to access those. No hotplug.

It is not a generic USB host like you would use with Poseidon.



The Z3 RAM (256MB)...
Forum: support.Hardware 14 November 2022, 13:10
Replies: 391
Views: 88,806
Posted By Jope
My comments on the card itself are along the same...

My comments on the card itself are along the same lines. The USB is its weakest point, so potential buyers should definitely keep that in mind.

Lukas/Minute gladly takes open source contributions...
Forum: support.Hardware 14 November 2022, 12:52
Replies: 391
Views: 88,806
Posted By Jope
Hmm, some of us owners might say things like it...

Hmm, some of us owners might say things like it replaced my Picasso IV, but I don't think Minute himself has marketed it as such?

You can check what his selling points are from:...
Forum: support.Apps 13 November 2022, 21:05
Replies: 3
Views: 330
Posted By Jope
Deficons was originally part of the NewIcons...

Deficons was originally part of the NewIcons package. It's still available there.
Forum: Nostalgia & memories 11 November 2022, 15:09
Replies: 443
Views: 19,492
Posted By Jope
It's interesting to hear about how you guys...

It's interesting to hear about how you guys tended to pay some bloke copying disks at his flat (or some car boot sale) for your new warez. That's just something that never happened in my circles,...
Forum: support.Hardware 10 November 2022, 10:48
Replies: 2
Views: 212
Posted By Jope
They are revision numbers. There's no guarantee...

They are revision numbers. There's no guarantee that they were matched at the factory. If the part fits, then it fits.
Forum: Amiga scene 10 November 2022, 10:45
Replies: 6
Views: 1,152
Posted By Jope
A tall Chinon needs 12 volts for the motor. The...

A tall Chinon needs 12 volts for the motor. The Greaseweazle is best used with a PC drive anyway, Amiga drives are happy inside Amigas. :-)
Forum: support.Hardware 07 November 2022, 21:31
Replies: 2
Views: 311
Posted By Jope
You must select the correct settings for the two...

You must select the correct settings for the two clock jumpers when using a CPU card.

The BFG wants both in the INT position.
...
Forum: Retrogaming General Discussion 07 November 2022, 13:26
Replies: 10
Views: 783
Posted By Jope
I didn't mind Iridon. I actually saw this before...

I didn't mind Iridon. I actually saw this before I played Uridium, since my C64 life was a bit isolated.

I'd say Uridium is the better game of the two, but Iridon wasn't all terrible.
Forum: support.Hardware 07 November 2022, 13:24
Replies: 5
Views: 487
Posted By Jope
You would connect it to an eprom programmer and...

You would connect it to an eprom programmer and read it as a 27c010 chip, then try to find some human readable strings in the contents to determine what it actually is.

It is not a part that is...
Forum: support.Hardware 05 November 2022, 17:28
Replies: 5
Views: 385
Posted By Jope
There are vga -> 15kHz adapters out there from...

There are vga -> 15kHz adapters out there from times of old, but the image quality is absolutely terrible and you'll be looking at interlaced flickery blurry mess.
Forum: request.Apps 03 November 2022, 11:31
Replies: 206
Views: 66,390
Posted By Jope
Yeah, I also feel there really is no middle...

Yeah, I also feel there really is no middle ground here. Only beating a core i9 and doing blazingly fast mac emulation are valid reasons for any m68k CPU's existence. If it can't handle those, then...
Forum: support.Hardware 02 November 2022, 14:38
Replies: 17
Views: 1,082
Posted By Jope
I've noticed the same. The quality varies a lot....

I've noticed the same. The quality varies a lot. :-)
Forum: support.Hardware 01 November 2022, 11:29
Replies: 21
Views: 1,756
Posted By Jope
Do you still have the plastic between the...

Do you still have the plastic between the motherboard and the bottom shield? Is everything clear between the floppy drive and bottom shield when assembling the machine?
Forum: support.Hardware 01 November 2022, 09:15
Replies: 9
Views: 657
Posted By Jope
3. addition to the previous, the no-click bit was...

3. addition to the previous, the no-click bit was introduced in V36, releases before that required actual patches to trackdisk.device to get noclick.

4. I once noticed that the OS3.1 install...
Forum: Hardware pics 31 October 2022, 17:02
Replies: 6
Views: 566
Posted By Jope
Oh man, delivered so convincingly that no doubt...

Oh man, delivered so convincingly that no doubt five years from now someone will unironically call this one a mickey. :-D
Forum: support.Hardware 31 October 2022, 15:48
Replies: 17
Views: 1,360
Posted By Jope
A PC psu is handy for powering a ton of storage...

A PC psu is handy for powering a ton of storage devices, one of the main rationales for moving to a tower case in the first place.
Forum: support.Hardware 27 October 2022, 12:55
Replies: 391
Views: 88,806
Posted By Jope
I used to run mine with a kickflash os4 which did...

I used to run mine with a kickflash os4 which did the necessary reboot for me, so it was always fully ready when the OS was loading for real. :-)

But these days I run the no-mem firmware, I really...
Showing results 1 to 40 of 9289

 
Forum Jump

All times are GMT +2. The time now is 11:54.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2022, vBulletin Solutions Inc.
Page generated in 0.79531 seconds with 10 queries