English Amiga Board


Go Back   English Amiga Board > Search Forums

Showing results 1 to 40 of 945
Search took 0.08 seconds.
Search: Posts Made By: supaduper
Forum: support.Hardware 07 April 2021, 11:57
Replies: 6
Views: 237
Posted By supaduper
Look at the jumper on the Gotek it should be on...

Look at the jumper on the Gotek it should be on S0 I think or S1 cant remember which one so try that and it should boot
Forum: News 04 April 2021, 11:56
Replies: 451
Views: 89,363
Posted By supaduper
I`m sure PFSaio locks the drive to read only if...

I`m sure PFSaio locks the drive to read only if there is a problem found by PFS so might want to ask Toni
Forum: support.Hardware 02 April 2021, 15:47
Replies: 4
Views: 201
Posted By supaduper
Yes you have removed some of the contact material...

Yes you have removed some of the contact material on the Keyboard ribbon, and you must always lift up the white ribbon clip/clamp before removing the Ribbon as if you do not then just pulling the...
Forum: support.Hardware 18 March 2021, 00:34
Replies: 3
Views: 318
Posted By supaduper
You do not need to remove the old components

You do not need to remove the old components
Forum: support.Hardware 11 March 2021, 23:22
Replies: 2
Views: 253
Posted By supaduper
Great work fella

Great work fella
Forum: support.Hardware 06 March 2021, 17:17
Replies: 3
Views: 318
Posted By supaduper
You will find that some component in the delay...

You will find that some component in the delay line has gone bad, and some of these components are no longer available, the best way to do it now is to replace the CXA1145 with the CXA2075 which has...
Forum: support.Hardware 06 March 2021, 10:04
Replies: 13
Views: 385
Posted By supaduper
Also check that those 4 components are removed as...

Also check that those 4 components are removed as shown in that link on the A1200 motherboard as these will give you timing problems with most accelerators and Jens ones, I know because I had the...
Forum: support.Hardware 28 February 2021, 18:27
Replies: 12
Views: 405
Posted By supaduper
Have you tried another RGB cable ?, as some of...

Have you tried another RGB cable ?, as some of them are poorly made and wires in the 23 pin hood can come loose and short out especialy if the lead is loose/floppy where it actually enters the hood,...
Forum: support.Hardware 13 February 2021, 08:24
Replies: 3
Views: 268
Posted By supaduper
the CPU command must be in your C: drawer if it...

the CPU command must be in your C: drawer if it is Try this in your startup sequence

CPU FASTROM BURST >NIL:
Forum: support.Hardware 10 February 2021, 12:42
Replies: 29
Views: 1,269
Posted By supaduper
One of these or similar...

One of these or similar...
Forum: support.Hardware 08 February 2021, 07:16
Replies: 5
Views: 280
Posted By supaduper
Try WinImage , you can write your larger image to...

Try WinImage , you can write your larger image to a smaller SD or CF card, it will come up with a cycling error error after writing but it will have copied the RDB and you will then just have to...
Forum: support.Hardware 05 February 2021, 21:58
Replies: 14
Views: 622
Posted By supaduper
Great stuff mate

Great stuff mate
Forum: support.Hardware 05 February 2021, 09:59
Replies: 29
Views: 1,269
Posted By supaduper
Yes if you use the 27C800 (1mb) eprom then just...

Yes if you use the 27C800 (1mb) eprom then just write the file to both banks First bank 0 then bank 1, otherwise obviously if using the 27C400 (512kb) then just write to bank 1
Dont forget when...
Forum: support.Hardware 20 January 2021, 14:00
Replies: 6
Views: 345
Posted By supaduper
Lo = u6b

Lo = u6b
Forum: Amiga scene 25 December 2020, 13:09
Replies: 45
Views: 1,758
Posted By supaduper
Merry Christmas and happy New year to all fellow...

Merry Christmas and happy New year to all fellow Amigans :)
Forum: project.CD32 Conversion 24 December 2020, 21:12
Replies: 103
Views: 17,924
Posted By supaduper
Hey bud I have emailed you regarding the probs...

Hey bud I have emailed you regarding the probs you are having and I should be able to help you out

**NOTE
Just to add this info here:

Regarding the TF330 there is a bug in V2 of the firmware ...
Forum: project.CD32 Conversion 16 December 2020, 18:40
Replies: 230
Views: 68,754
Posted By supaduper
Do you realise how much time he spent on...

Do you realise how much time he spent on compiling these great compilations ?, these were done out of a love for the Cd32 community and and I will will always support that and actually if you look at...
Forum: project.CD32 Conversion 20 November 2020, 18:40
Replies: 24
Views: 3,866
Posted By supaduper
Excellent work fella I tried it on a...

Excellent work fella

I tried it on a expanded CDTV with 3.1 and 2.3 ex roms with 2mb chip and 8mb of ram and it works fine

Just to add it also works fine on the CD32 :)

Donated :)
Forum: support.Hardware 23 September 2020, 19:45
Replies: 27
Views: 2,679
Posted By supaduper
TF330 and CP2 info can be found in this forum ...

TF330 and CP2 info can be found in this forum
https://www.exxoshost.co.uk/forum/viewtopic.php?f=70&t=1716
Forum: support.Hardware 22 September 2020, 08:00
Replies: 27
Views: 2,679
Posted By supaduper
Disable is not fixed yet

Disable is not fixed yet
Forum: support.Hardware 21 September 2020, 23:07
Replies: 27
Views: 2,679
Posted By supaduper
Here is a link to my v3 NVram fix ...

Here is a link to my v3 NVram fix
https://mega.nz/file/Y8pD3QDZ#yc9J1fECldmg8Q-V9KaDffT2i54LMFANIai7C0-DIU0
Forum: support.Hardware 21 September 2020, 21:21
Replies: 27
Views: 2,679
Posted By supaduper
TF330 V3 is the Bust with NVRAM fix combined :)

TF330 V3 is the Bust with NVRAM fix combined :)
Forum: support.Hardware 21 September 2020, 11:14
Replies: 27
Views: 2,679
Posted By supaduper
for the TF328 and TF330 I have put the versions...

for the TF328 and TF330 I have put the versions below, I do not build the TF530 or the TF356 so Allen can fill those in :)
Forum: support.Hardware 09 September 2020, 16:02
Replies: 13
Views: 836
Posted By supaduper
Looks like some component is breaking down after...

Looks like some component is breaking down after heating up as you say you leave it for a while and it plays again, not scientific but turn it on and have a feel around with one of your pinkys and...
Forum: support.Hardware 02 September 2020, 19:20
Replies: 13
Views: 670
Posted By supaduper
Is the 23pin RGB video out working ? this is...

Is the 23pin RGB video out working ? this is taken direct from the Video DAC, here is the schematic for the Video circuit, you will have to check and see that the R G B are getting to the CXA2075 and...
Forum: News 02 September 2020, 19:06
Replies: 90
Views: 6,542
Posted By supaduper
No , the switches it has are , CHECK, REPAIR,...

No , the switches it has are , CHECK, REPAIR, SEARCH,UNFORMAT, but I agree salvage to another device will be a must have :)
Forum: News 02 September 2020, 18:04
Replies: 90
Views: 6,542
Posted By supaduper
Toni also has the Diskdoctor for PFS aio, command...

Toni also has the Diskdoctor for PFS aio, command line only but it`s a great tool if ever you need to repair a partition
Forum: support.Hardware 02 September 2020, 17:58
Replies: 13
Views: 670
Posted By supaduper
Glad I could help out fella, it`s a great...

Glad I could help out fella, it`s a great solution to the failing Delay Line circuits on our Amigas :)
Forum: News 02 September 2020, 16:48
Replies: 90
Views: 6,542
Posted By supaduper
Nice little comparison test and nicely put...

Nice little comparison test and nicely put together vid, I like SFS, but as always PFSaio ver 19.2 for the win !:bowdown
Forum: support.Hardware 30 August 2020, 11:49
Replies: 13
Views: 670
Posted By supaduper
I have a couple of 2075m chips, contact me for...

I have a couple of 2075m chips, contact me for info
Forum: support.Hardware 28 August 2020, 15:23
Replies: 7
Views: 434
Posted By supaduper
Yes it sounds like your A2000 keyboard is faulty,...

Yes it sounds like your A2000 keyboard is faulty, I don`t know about them so perhaps someone with knowledge can answer your question
Forum: support.Hardware 28 August 2020, 14:16
Replies: 7
Views: 434
Posted By supaduper
The PS/2 on the Kipper riser is picky with some...

The PS/2 on the Kipper riser is picky with some keyboards, rule of thumb is the older the better, so try another one if you can like Dell, Compaq, HP
Forum: support.Hardware 14 August 2020, 13:35
Replies: 32
Views: 1,323
Posted By supaduper
What cable are you using for the Video out ?...

What cable are you using for the Video out ? Composhite or the 23 pin RGB port ? have you tried different video cable ?
Forum: support.Hardware 12 August 2020, 12:27
Replies: 11
Views: 844
Posted By supaduper
Yep I have done a few, it works on all Amigas...

Yep I have done a few, it works on all Amigas including the CD32, I would do as you say and offer it to your customers, it makes the composhite bareable :)
and utsource have the CXA2075m and they...
Forum: support.Hardware 12 August 2020, 11:53
Replies: 11
Views: 844
Posted By supaduper
How to here: https://www.ikod.se/cxa2075m/

How to here:
https://www.ikod.se/cxa2075m/
Forum: support.Hardware 12 August 2020, 09:12
Replies: 11
Views: 844
Posted By supaduper
Yes if the Delay circuit fails ( Z222) then yes...

Yes if the Delay circuit fails ( Z222) then yes it can result in no video, try the 23 pin RGB video out on the machine if you get a picture then the fault lies in the Delay circuit, as mentioned...
Forum: support.Hardware 11 August 2020, 22:30
Replies: 8
Views: 740
Posted By supaduper
Yes you can use the gotek externally , you can...

Yes you can use the gotek externally , you can buy a ready to go cable off the Bay or on Amibay I think

with my Blizzard giving me the power on problem I hacked it with a pice of cardboard lol, I...
Forum: support.Hardware 11 August 2020, 21:59
Replies: 8
Views: 740
Posted By supaduper
The no power after switching off could be the...

The no power after switching off could be the Expasion card , bad contact ECT, take it out and see if it is any better, I had a Blizzard 030 that used to give me that condition.

Regarding the...
Forum: support.WinUAE 11 August 2020, 11:09
Replies: 4
Views: 628
Posted By supaduper
As Thomas says use PFS3 aio, a much better choice...

As Thomas says use PFS3 aio, a much better choice now that it been updated over the last year to iron out the bugs by Toni Willen, I never use anything else , but if using on a 68000 machine you will...
Forum: support.Hardware 01 June 2020, 14:58
Replies: 270
Views: 38,401
Posted By supaduper
TF360 coming very very soon :) 67572

TF360 coming very very soon :)

67572
Showing results 1 to 40 of 945

 
Forum Jump

All times are GMT +2. The time now is 17:34.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.
Page generated in 0.13084 seconds with 10 queries