English Amiga Board


Go Back   English Amiga Board > Search Forums

Showing results 1 to 40 of 7609
Search took 0.66 seconds.
Search: Posts Made By: Jope
Forum: support.WinUAE Yesterday, 10:16
Replies: 2
Views: 106
Posted By Jope
Try right control as your right amiga. In the...

Try right control as your right amiga. In the Miscellaneous section.
Forum: support.Hardware 25 February 2020, 20:57
Replies: 26
Views: 439
Posted By Jope
It should work for a Gotek.

It should work for a Gotek.
Forum: support.Hardware 25 February 2020, 17:40
Replies: 26
Views: 439
Posted By Jope
The bitstream from the floppy data bus never...

The bitstream from the floppy data bus never passes through the CPU, it is fed directly into Paula.

What gets manipulated is when software code wants to set the drive selects in the CIA registers....
Forum: support.Hardware 25 February 2020, 17:37
Replies: 11
Views: 446
Posted By Jope
Ah, too bad. In other PVM/BVM displays the...

Ah, too bad. In other PVM/BVM displays the int/ext sync feature is quite relevant sometimes when connecting various different signal sources.
Forum: support.Hardware 25 February 2020, 15:19
Replies: 26
Views: 439
Posted By Jope
It works in a different way, by patching the...

It works in a different way, by patching the software in RAM. Hence it is not transparent to the software. Any direct access past trackdisk.device will fail.
Forum: News 25 February 2020, 09:06
Replies: 527
Views: 81,247
Posted By Jope
So what's the deal with these? Will they ever be...

So what's the deal with these? Will they ever be mass produced? Can anyone ever buy one again?
Forum: support.Hardware 25 February 2020, 08:51
Replies: 11
Views: 446
Posted By Jope
When you had the monitor set to RGB input, did...

When you had the monitor set to RGB input, did you try both positions of the ext sync button on the bottom right corner of the button grid?
Forum: support.Hardware 25 February 2020, 08:49
Replies: 14
Views: 1,466
Posted By Jope
Your guess is as good as mine :-)

Your guess is as good as mine :-)
Forum: support.Hardware 24 February 2020, 22:16
Replies: 14
Views: 1,466
Posted By Jope
Apparently it will be getting RTG based on the...

Apparently it will be getting RTG based on the Amiga Reloaded wiki page.

http://wiki.icomp.de/wiki/Commodore_A1200_Reloaded

Or perhaps this is only for the version that is integrated into the...
Forum: support.Hardware 24 February 2020, 21:06
Replies: 11
Views: 446
Posted By Jope
Did you already try both settings for ext sync on...

Did you already try both settings for ext sync on your PVM?
Forum: support.Hardware 23 February 2020, 22:11
Replies: 36
Views: 1,055
Posted By Jope
Yes, the original Arkanoid takes the quadrature...

Yes, the original Arkanoid takes the quadrature signals directly. Taito classic pinout and IIRC they're hooked up to the pins for left and right joystick. We're a bit far from Amigas now, so let's...
Forum: support.Hardware 23 February 2020, 16:35
Replies: 7
Views: 288
Posted By Jope
You must have a working +4GB capable scsi.device...

You must have a working +4GB capable scsi.device resident in your system before you resize.
Forum: support.Hardware 23 February 2020, 16:34
Replies: 1,165
Views: 420,567
Posted By Jope
Good to hear this kind of report. :-) People have...

Good to hear this kind of report. :-) People have been rather pessimistic. Which method did you use back then?
Forum: support.Hardware 22 February 2020, 12:46
Replies: 7
Views: 288
Posted By Jope
If your CF is larger than the HD, the quickest is...

If your CF is larger than the HD, the quickest is to probably just take an image and restore it to the CF, then run Thomas' fixhddsize..
Forum: support.Hardware 22 February 2020, 12:43
Replies: 1,165
Views: 420,567
Posted By Jope
How long has it been from the earliest one you...

How long has it been from the earliest one you did?
Forum: Amiga scene 20 February 2020, 10:06
Replies: 233
Views: 21,874
Posted By Jope
It really is a wonderful A500 enabler.

It really is a wonderful A500 enabler.
Forum: support.Hardware 20 February 2020, 10:01
Replies: 15
Views: 2,077
Posted By Jope
The thread's still active on this subforum: ...

The thread's still active on this subforum:
http://eab.abime.net/showthread.php?t=100942
Forum: MarketPlace 19 February 2020, 13:59
Replies: 21
Views: 1,350
Posted By Jope
Thankfully the superkick image goes into the end...

Thankfully the superkick image goes into the end of motherboard Fast RAM if you have some.
Forum: support.Hardware 19 February 2020, 12:24
Replies: 9
Views: 243
Posted By Jope
Brand name male male 50-68 adapters have worked...

Brand name male male 50-68 adapters have worked well for me:
https://www.ebay.de/itm/HP-5182-4551-Adapter-50-pol-SCSI-Buchse-auf-68-pol-SCSI-Buchse-Male-BULK-1A/202797154203
Forum: support.Hardware 19 February 2020, 07:26
Replies: 173
Views: 10,492
Posted By Jope
So the good results you got here are with 6.3.0...

So the good results you got here are with 6.3.0 beta?
Forum: support.Hardware 19 February 2020, 07:21
Replies: 6
Views: 216
Posted By Jope
You need to install SFS v1.277 with the dostype...

You need to install SFS v1.277 with the dostype 0x53465300 to your scsi drive. Perhaps also remove the SFS v1.279 from there as your partitions do not use it.
Forum: support.Hardware 18 February 2020, 20:31
Replies: 19
Views: 540
Posted By Jope
Alternatively: buffered sync dongle + vga -> 5bnc...

Alternatively: buffered sync dongle + vga -> 5bnc cable + ethernet bnc t connector for a dirty sync combination. :-)

Maybe the buffer won't burn in the sync dongle with prolonged use, but at least...
Forum: support.Hardware 18 February 2020, 19:15
Replies: 6
Views: 216
Posted By Jope
My speculation also concerns filesystems on each...

My speculation also concerns filesystems on each drive's RDB.
Forum: support.Hardware 18 February 2020, 13:43
Replies: 6
Views: 275
Posted By Jope
If the flyback case is arcing because it is...

If the flyback case is arcing because it is cracked, then usually the only way forward is to replace the flyback.
Forum: support.Hardware 18 February 2020, 09:11
Replies: 9
Views: 243
Posted By Jope
When the host adapter is 50 pin, it doesn't...

When the host adapter is 50 pin, it doesn't actually matter that much, as long as your termination is correct.

The easiest most surefire way to do it is to disable termination in all devices and...
Forum: support.Hardware 18 February 2020, 09:07
Replies: 6
Views: 275
Posted By Jope
You should reflow the solder joints in all the...

You should reflow the solder joints in all the connectors at the back and under the flyback transformer.

These are getting old enough that caps should be replaced.
Forum: Retrogaming General Discussion 17 February 2020, 09:56
Replies: 24
Views: 1,151
Posted By Jope
- You can load lots of high quality (well in...

- You can load lots of high quality (well in amiga terms high) samples into ProTracker.
- You can open lots of colourful screens when multitasking. Of course this would require more fast ram too.
...
Forum: support.Hardware 17 February 2020, 09:26
Replies: 24
Views: 714
Posted By Jope
Yes, because it is not there to fix uneven...

Yes, because it is not there to fix uneven magnetization like in the OP's monitor. The degauss circuit is there so that the monitor's shadow mask (which is assumed to be evenly magnetized) is in...
Forum: support.Hardware 16 February 2020, 17:01
Replies: 24
Views: 714
Posted By Jope
One thing you might want to check is the degauss...

One thing you might want to check is the degauss coil that is wrapped around the tube.. Is it still properly in place.
Forum: support.Hardware 16 February 2020, 11:58
Replies: 36
Views: 1,055
Posted By Jope
Yes, it is allowed. Any links to a web store or...

Yes, it is allowed. Any links to a web store or ebay will of course go bad eventually, but such is life. It's best to avoid it, but of course use your common sense.. In a situation like this it's...
Forum: News 16 February 2020, 11:48
Replies: 90
Views: 8,295
Posted By Jope
Ahh, super happy about 4.4.. The previous...

Ahh, super happy about 4.4.. The previous release's performance was terrible on my machine.
Forum: Amiga scene 16 February 2020, 11:02
Replies: 233
Views: 21,874
Posted By Jope
So, thread necro time. Mid-February 2020 is upon...

So, thread necro time. Mid-February 2020 is upon us. Let's see what it brings.
Forum: support.Hardware 15 February 2020, 18:07
Replies: 24
Views: 714
Posted By Jope
A degauss wand might be needed here.

A degauss wand might be needed here.
Forum: support.Hardware 15 February 2020, 18:06
Replies: 23
Views: 7,229
Posted By Jope
Done.

Done.
Forum: support.Hardware 14 February 2020, 20:55
Replies: 17
Views: 736
Posted By Jope
Yes, you will need the boot disk. The whole point...

Yes, you will need the boot disk. The whole point of the exercise is to have a useful workbench setup on the PCMCIA CF card for you. If you do not move the system assigns, the system will not work...
Forum: support.Hardware 14 February 2020, 20:50
Replies: 2
Views: 211
Posted By Jope
Yes, the A1200 keyboards are the same among each...

Yes, the A1200 keyboards are the same among each other.
Forum: support.Hardware 14 February 2020, 15:08
Replies: 17
Views: 736
Posted By Jope
No, leave the one on the compact flash alone for...

No, leave the one on the compact flash alone for now. The stuff in my post was for the startup-sequence on your bootdisk!

I would probably use the ed editor myself as it needs to be a text file.
...
Forum: support.Hardware 14 February 2020, 15:02
Replies: 36
Views: 1,055
Posted By Jope
Good show! The Arkanoid feeling is a very...

Good show!

The Arkanoid feeling is a very specific one though, thanks to the gearing. I have one genuine arkanoid spinner and one 3rd party one that I use with my Taito boards, now it's the only...
Forum: Retrogaming General Discussion 14 February 2020, 12:32
Replies: 57
Views: 2,307
Posted By Jope
Please everyone: do not use bogomips as any kind...

Please everyone: do not use bogomips as any kind of comparison between different CPUs. It is a totally meaningless value.
Forum: support.Hardware 13 February 2020, 15:18
Replies: 17
Views: 736
Posted By Jope
It is possible to make a boot disk which...

It is possible to make a boot disk which transfers the system assigns to the CF card. It is even possible to make a small reset resident ram drive which does this for you.

Fat32 is not necessarily...
Showing results 1 to 40 of 7609

 
Forum Jump

All times are GMT +2. The time now is 00:33.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Page generated in 0.50048 seconds with 10 queries