English Amiga Board


Go Back   English Amiga Board > Search Forums

Showing results 1 to 40 of 380
Search took 0.04 seconds.
Search: Posts Made By: r.cade
Forum: support.Hardware 25 February 2020, 14:42
Replies: 11
Views: 407
Posted By r.cade
Perfect. Better than a 1080/1084. It's one of the...

Perfect. Better than a 1080/1084. It's one of the "HR/high res" PVM's, which means just finer dot pitch I think.
Forum: Retrogaming General Discussion 25 February 2020, 04:22
Replies: 34
Views: 1,199
Posted By r.cade
That's not exactly true- it will fit if you cut a...

That's not exactly true- it will fit if you cut a notch out of the back of the case, and make sure to insulate the top of the case so the Toaster doesn't short out.

I only know because I used to...
Forum: support.Hardware 25 February 2020, 04:15
Replies: 11
Views: 407
Posted By r.cade
I have the 5-BNC RGB cable, RGBHV. So the sync...

I have the 5-BNC RGB cable, RGBHV. So the sync lines are separate. My PVM only has the one sync input, so I combine them with a T connector and it works fine. Maybe the sync line on your cable is not...
Forum: support.Hardware 22 February 2020, 01:20
Replies: 10
Views: 311
Posted By r.cade
Sounds like it's locking up trying to access...

Sounds like it's locking up trying to access SCSI. I assume you don't have anything plugged into SCSI at all? Are the termination resistors on the motherboard? Plug your hard drive(s) back in as...
Forum: Amiga scene 21 February 2020, 04:17
Replies: 802
Views: 153,059
Posted By r.cade
Strangely, my ACA500+ doesn't work in either of...

Strangely, my ACA500+ doesn't work in either of my 500's, but works fine on my 1000. As long as it's seated right, anyway- it has to be propped up at a little bit of an angle to boot.
Forum: support.Hardware 09 February 2020, 22:58
Replies: 4
Views: 184
Posted By r.cade
Thanks very much, but unfortunately it's an...

Thanks very much, but unfortunately it's an entirely different card.
Forum: support.Hardware 09 February 2020, 21:37
Replies: 4
Views: 184
Posted By r.cade
Progressive Peripherals & Software ProRAM 2000

I have one of these cards in my "box of stuff". It appears to be fully populated, but no additonal RAM appears in my A2000 (or A3000) with it inserted.

I am unable to find any old manual or...
Forum: support.Hardware 19 January 2020, 22:38
Replies: 6
Views: 425
Posted By r.cade
Examine under high magnification and look for...

Examine under high magnification and look for dropped solder blobs somewhere. :)
Forum: support.Hardware 15 January 2020, 01:04
Replies: 14
Views: 532
Posted By r.cade
That's going to be very difficult to figure out...

That's going to be very difficult to figure out how to do that. I think your best bet will be to get a different accellerator and just set that aside in case you ever run across the memory board for...
Forum: MarketPlace 05 January 2020, 03:53
Replies: 2
Views: 294
Posted By r.cade
Well all I can do is offer... Will PM you.

Well all I can do is offer... Will PM you.
Forum: MarketPlace 04 January 2020, 21:11
Replies: 2
Views: 294
Posted By r.cade
Wanted: Amiga 500 case, or even just the bottom (USA)

Hello- I have recently resurrected my A500- it had all bad RAM and a dead keyboard. It is running again nicely!

Unfortunately, at some point someone dropped the computer and the bottom case is...
Forum: support.Hardware 03 January 2020, 07:08
Replies: 2
Views: 367
Posted By r.cade
I had some time today so I traced it down with my...

I had some time today so I traced it down with my logic probe. I was getting a garbage input on the reset pin of the keyboard CPU, which I traced to the 74LS27, then traced that to the 74LS123 that...
Forum: support.Hardware 09 December 2019, 01:26
Replies: 4
Views: 273
Posted By r.cade
Bad cable, bad termination, incompatible or bad...

Bad cable, bad termination, incompatible or bad drives.

I've also seen Kickstart versions cause this. On one of my A3000's, 2.04 works fine with most drives, 3.1 will lock up like yours with some...
Forum: support.Hardware 30 November 2019, 00:51
Replies: 52
Views: 2,223
Posted By r.cade
Mine works and I have a newer red one- I had to...

Mine works and I have a newer red one- I had to switch to the SD card adapter because no CF card would work anymore, but after that it is stable.
Forum: support.Hardware 22 November 2019, 16:28
Replies: 5
Views: 589
Posted By r.cade
It's a lot of custom logic. You can troubleshoot...

It's a lot of custom logic. You can troubleshoot the common parts (RAM and connector, soldering, power, etc.) but beyond that you'll be stuck.
Forum: support.WinUAE 19 November 2019, 02:39
Replies: 204
Views: 32,572
Posted By r.cade
This happens to me also on Windows 7 - with a...

This happens to me also on Windows 7 - with a good old GTX 770, anyway. Only 3 more months to go, right? (1/20/20 is EOL).

Why use newest Windows when we're emulating computers from the 80's and...
Forum: support.Hardware 16 November 2019, 21:45
Replies: 64
Views: 3,372
Posted By r.cade
Writing is not an easy thing to implement in a...

Writing is not an easy thing to implement in a one-size-fits-all way. The only thing the drive knows and sends is the "bitstream" and when the index signal happens, and that is all that can be stored...
Forum: support.Hardware 15 November 2019, 21:58
Replies: 7
Views: 413
Posted By r.cade
Sure you have the chip aligned properly? It seems...

Sure you have the chip aligned properly? It seems like some 600's have larger socket than the ROM and it can be offset. I may be thinking of the 1200 though.
Forum: support.Hardware 13 November 2019, 23:30
Replies: 17
Views: 665
Posted By r.cade
Good deal. Another one saved from the scrap heap....

Good deal. Another one saved from the scrap heap. Mine still has a keyboard that will not come out of reset that I need to look at.
Forum: support.Hardware 11 November 2019, 05:02
Replies: 17
Views: 665
Posted By r.cade
I recently replaced all the RAM on my A500 (all...

I recently replaced all the RAM on my A500 (all 16 chips) and tore up at least 3 traces/vias. I noticed a couple of them, but not all of them.

Go through the schematic - almost all of the lines...
Forum: support.Hardware 07 November 2019, 04:52
Replies: 6
Views: 307
Posted By r.cade
What about with stock ROMs? One of my A3000's...

What about with stock ROMs? One of my A3000's doesn't work the 3.1.4 AMD EPROMs that are sold, while the other one does (and no it's not ROM tower issue).
Forum: MarketPlace 04 November 2019, 02:54
Replies: 3
Views: 555
Posted By r.cade
It's fixed! Thank you... I had to look over...

It's fixed! Thank you...

I had to look over all the RAM wiring again and found another issue, but it is alive!
Forum: support.Hardware 31 October 2019, 17:13
Replies: 22
Views: 1,070
Posted By r.cade
It may be just the floppy drive is dead. That can...

It may be just the floppy drive is dead. That can cause it to hang on boot. Disconnect it completely and see if anything changes- I don't recall if the "Insert Kickstart" screen comes up if it...
Forum: MarketPlace 28 October 2019, 18:43
Replies: 3
Views: 555
Posted By r.cade
That's very kind of you, thanks! I have sent a PM.

That's very kind of you, thanks! I have sent a PM.
Forum: support.WinUAE 27 October 2019, 02:11
Replies: 3
Views: 405
Posted By r.cade
Because those file systems only support 2GB. It...

Because those file systems only support 2GB. It has "wrapped around" and only shows you the last ~850M
Forum: Retrogaming General Discussion 22 October 2019, 19:59
Replies: 15
Views: 1,031
Posted By r.cade
I watched the long play and I don't see how you...

I watched the long play and I don't see how you are supposed to know what background elements you can pass through vs. crash into... It all looks the same to me.
Forum: MarketPlace 10 October 2019, 05:04
Replies: 3
Views: 555
Posted By r.cade
Wanted: Fat Agnus (Any version)

Hello,

I have recently resurrected an old Rev5 A500. *all* of the RAM chips were bad... 12 were shorted, the other 4 were blown. I don't know what happened to it, but I suspect maybe someone used...
Forum: support.Hardware 09 October 2019, 03:51
Replies: 6
Views: 379
Posted By r.cade
It should work. Should be able to use HQ5 with no...

It should work. Should be able to use HQ5 with no problem...
Forum: support.Hardware 07 October 2019, 15:16
Replies: 7
Views: 434
Posted By r.cade
Softboot is on Aminet.

Softboot is on Aminet.
Forum: support.Hardware 06 October 2019, 04:42
Replies: 7
Views: 434
Posted By r.cade
That's not exactly true - you don't have to...

That's not exactly true - you don't have to install 1.4 ROMs. You can download softboot and boot any 3000-specific ROM...
Forum: support.Hardware 26 September 2019, 15:49
Replies: 2
Views: 367
Posted By r.cade
Amiga 500 Keyboard

I have an A500 where the keyboard has failed. It is in good physical condition, but when plugged into the motherboard (tried more than one) the CAPS LOCK is solid, no blinking, and no response from...
Forum: support.Hardware 30 August 2019, 15:24
Replies: 15
Views: 612
Posted By r.cade
Yes, take a look sometime. It will be like a...

Yes, take a look sometime. It will be like a murder scene. You won't like it. :)
Forum: support.Hardware 30 August 2019, 15:22
Replies: 15
Views: 612
Posted By r.cade
If you just had that recapped a couple years ago,...

If you just had that recapped a couple years ago, whomever did it half-assed it. They didn't clean or neutralize the board. They may have even only replaced the caps that were visibly failing, so now...
Forum: Retrogaming General Discussion 17 August 2019, 17:32
Replies: 103
Views: 5,676
Posted By r.cade
I got a Vic-20 in 82 or 83 with Omega Race and...

I got a Vic-20 in 82 or 83 with Omega Race and Congo Bongo (ugh, the horror of that one).
Forum: support.Hardware 25 July 2019, 23:47
Replies: 43
Views: 2,600
Posted By r.cade
I don't think I've even ever seen 3.5" drives...

I don't think I've even ever seen 3.5" drives with belts. I thought by that time all the motors were direct drive...
Forum: New to Emulation or Amiga scene 25 July 2019, 03:48
Replies: 21
Views: 2,259
Posted By r.cade
I would expect they just mean "the best they...

I would expect they just mean "the best they could find" kind of like Cracker Barrel apple butter... (Sorry, regional joke)
Forum: MarketPlace 09 July 2019, 22:43
Replies: 7
Views: 443
Posted By r.cade
Missing daughter card causes yellow screen, not...

Missing daughter card causes yellow screen, not red.
Forum: support.Hardware 02 July 2019, 04:08
Replies: 13
Views: 467
Posted By r.cade
You put the original working 3.1 ROM in? I've...

You put the original working 3.1 ROM in? I've seen the newer 3.1.4 AMD EPROMs not work properly in some Amigas.

I bought a set that is on AMD EPROMs and it worked in one A3000 and not at all in...
Forum: support.WinUAE 16 June 2019, 06:06
Replies: 9
Views: 1,604
Posted By r.cade
I always did a silly low-tech RAM check....

I always did a silly low-tech RAM check. Drag/drop folders/disk to RAM. If it fills up and runs out of RAM before locking up or crashing, RAM is probably good.

But this doesn't really help tell...
Forum: support.Hardware 15 June 2019, 23:22
Replies: 6
Views: 420
Posted By r.cade
If it works with the A2630 but not stock, it...

If it works with the A2630 but not stock, it isn't likely Agnus or chip RAM issue. I would suspect the 68000 or socket.
Showing results 1 to 40 of 380

 
Forum Jump

All times are GMT +2. The time now is 08:16.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.
Page generated in 0.09367 seconds with 10 queries