Kipper2k CD32 Riser - RGB (DB23) and PC Keyboard (PS/2) Ideal for TF328
 

I have built a number of the Kipper V6.0 Riser boards ideal for use with you TF328!

They come fully populated with a PIC chip for the Keyboard interface and brand new DB23 connectors. The edge connectors and MiniDIN are TE Connectivity AMP brand.

At the moment I have enough to build 8 with RGB (DB23)

Prices for one including delivery and insured are as follows:

UK £30 (Was £32)
Europe £36 (Was £37)
Canada / USA £37 (Was £38 )

Non tracked, sent at your risk!
Europe £32
USA £33

For other locations and for example if you you to buy 3 or 5 etc I will calculate a cost.

I will only except Paypal Gift as this is not a commercial product.
Also it's your responsibility to ensure your TF328 or another product is insulted from the shielding inside your CD32!
There may be a delay in you getting these boards if demand is faster than I can produce them.

Is it possible to order them with options, say like green pcb color to match the CD32 pcb and without PS/2-interface?

Not at the moment sorry.
I ordered red PCB's to match the TF328.

If I sell out I will consider preordering without components, but as it stands I have bought all of the components for this batch.

Thanks for the info!

Arrived and looks grand - will be giving it a proper test tonight :D thanks!

Are these 100% compatible with TF328 when the PIC is programmed and fitted? I did read somewhere that there was some issues with the PIC firmware preventing boot on some risers?

It has the CF cut-out any photos of it all fitting together with the CF card mounted?

As far as I know the 18 pin PIC on the Kipper2k design works great, it's the smaller pic used on some risers that cause the issue. I'll try and get some pics when I put it all together this weekend :)

Thanks indigolemon.

This is how it sits with my TF328 ignore the tape on the TF328.
I am selling the v6 board, like indigolemon mentions it uses the 18pin PIC which works as should be. It was the pre v6 ones that didn't work.

Just so you all know I have 12 riser boards left at the moment.

I'll take one of those, can you PM me the payment link (incl. p&p to denmark) ?

PS: Are you selling complete TF328's too ?

Is that lower part top left wide enough to easily route a IDE cable out of the CD32?

There is enough room to feed a IDE cable out through the gap anywhere through the top :) and the 18 pin PIC chip works great

Yeah but will it work? The IDE is not buffered.

You could also use an IDE - SD adaptor and one of them flexible extensions, then you wouldn't need to bring power out of the CD32.

@akira ive had success with a long ide cable .

I am down to my last 6 riser boards now.

Although I do have another batch on their way.

I just received mine today, and very pleased with it :) - highly recommended !

Btw, could you direct me to a good RGB->HDMI combo of cable and upscaler box ?

Updated first post with reduced pricing and untracked option with Euro / USA.

Interested in 2, do they come with the DB23 connectors?