Winuae 5.2 shapeshifter and fusion screen issue
 

on winuae 5.2 for a strange reason when I run shapeshifter or fusion the MAC screen appears small in the low-left side of the screen

this is really rare because in winuae 5.1 everything is fine as always

can any1 test Fusion or Shapeshifter in winuae 5.2? thx

If you want anyone trying to reproduce this, then upload your uae config file, and also in what Shapeshifter screenmode does this occurs?

the screen I'm using in shapeshifter is UAE 640x480 8 bits, driver:Picasso96

in Fusion the same problem occurs, I'm using the P96DirectXL driver and also the screen is set on the mac side at 640x480 8 bits

the MAC screen takes up a quarter of the monitor screen appears very small in the low-left of the monitor

can you check this?

No problems here. Does the same screenmode behave normally in Workbench?

in Workbench 640x480 x 8bits it behave correctly I just tested it, the screen is normal very well centered

the issue happens when passes from a 1440x1080 x32 bits workbench screen to a 640x480 x 8 bits (shapeshifter screen)

however if I set the workbench first to 640x480 and then I launch shapeshifter everything is fine

so this is really rare because this not happens in winuae 5.1 and previous versions

Does it happen in windowed mode? This is always the very first question :)

it happens only in fullscreen mode

I just tested this in full-window mode and everything is fine, but I don't like to use the full-window mode because when I press the middle mouse button it don't return to windows and I get stuck in a winuae windows

anyways I'm sure something was changed in 5.2 that causes this issue

If it only happens in RTG fullscreen mode: 5.3 beta should have already fixed it.

ok I just downloaded 5.3b1 and yep it fixes this screen issue,
Thanks Mister