Problems with WinUAE 3.1.0 and Catweasel
 

Hello Folks,

i used WinUAE 3.1.0 with no Problems, evering was fine.
Now i have installed a Catweasel MK3 und read the instructions on winuae.net.
So i installed TVicPort.dll in the folder where winuae.exe lives (i also tested with winio.dll).

As i'm told in the doc i *did not* install the Catweasel drivers.
On the Amiga-Side i installed the latest multidisk.device (V3.65) and created a mountlist.
Also i ticked the Catweasel-ZII-Box on the Expansion-Tab.

Now if i mount the Drive i always get a "Not a DOS-Disk" and there is no access to the Drive.

But in the log i con see, that the TVicPort.dll (or winio.dll) gets initialized and the MK3 was found.

So here are my Questions: Do i have to install any kind of pci.library?
Do i have to install the Catweasel-Drivers from icomp?
Is there somethin else i'm missing?

Also i noticed, if i tick the Catweasel-ZII-Box i get continously Key-Down-Events with Code 0x7F. I think this has to do with either Keyboard or Joystick Hardwarefeatures of the Catweasel, but i have nothing connected to those Ports, only the 34-Pin Floppyconnector.

I hope someone can help me on this issue.

TIA
Sigma63

Direct catweasel support has been mostly unsupported for years.

Attach winuaelog.txt, hopefully it shows some problems. (Paths panel, tick full debugging, boot normally, attempt to use catweasel, enter GUI again, select winuaelog.txt).