Killer/CNCD and WinUAE

[Unregistered]

Has anyone here got CNCD's magnificent Killer working under WinUAE? I've tried to run it with various confs but each time I can only hear the music. Any config tips you have? Maybe a 68040 with some huge zorro3 memory? which resolution?

-Kimmo

[humanoid]

Hi,

If you happen to get it work please tell me too. I think that the main reason is that our demo used a lot of SMC and fpu commands in the prephase. (does a bit of precalc for sqrt in the 3D engine).

;)

your's truly humanoid of embassy ...

[StingRay]

Works perfectly fine for me in WinUAE. Used config: 68040/AGA/2MB Chip/64MB Fast.

[s4m]

Hi there,

someone can tell me where i can find the aga version of the magnificient "cncd killer?" please because i've just found the cgx archive...

thanks

sam

[TheCyberDruid]

Hi s4m,

you can find it here : http://pouet.net/prod.php?which=1135 :)

[s4m]

Hi TheCyberDruid

thank you very much

let's download...now!!

[Frog]

@Humanoid : I hope that now you know how to run your 3D engine under WinUAE it could help you to finish your "upcoming" (?) demo ;)

From A.D.A : We haven't utilized most of our "3d engine's" features at all. There are about 4-6 parts that are already finalized and some parts that are halfway and it makes about 12 + variations to have a decent demo.

[s4m]

i can't launch this demo on my 1200
screen freezing...
Arghhhh !!!

it's strange, maybe a bad unpack !

[StevenJGore]

Doesn't work on my real A1200 either.

[StingRay]

Did you start setpatch before? Demo needs it to detect AGA chipset.

[extralife]

it should run after setpatch as stingray points out and probly needs to be run from clean system (no startup....) for freeing up chippy. I don't seem to recall this one needs assigns and can't remember the fast ram requirements either, but i doubt it needs 32mb.
hmm, the .exe script should take care of both assign and setpatch, from what i can see, yea does assign lol.